Road Speed Trap: Can slowing down hit you in the ‘sweet spot?’

TORONTO — Slow down, save fuel everybody says. To a point, they’re correct, but there’s another wrinkle to consider when implementing a road-speed reduction strategy (or having one pushed on you by law).

Reducing road speed runs the risk of lowering engine speed to a point where drivability suffers. Reducing road speed by 10 mph today could cost you more than leaving it alone. Today’s engines are much more sensitive to speed, and don’t deliver optimum performance or fuel economy if you stray a couple of hundred rpm above or below the so-called "sweet spot."

Consider the following example, calculated with a Mack drivetrain (other OE drivetrain combinations would yield similar results with similar componentry):

A truck spec’d to run at 70 mph has a 10-speed transmission a 0.74 overdrive, 11R22.5 tires with 3.36 rear-axle ratio. Running at 70 mph gives us an engine speed of 1,425 rpm. Performance is good, as are power, gradability, and fuel economy.

Speed limiters could interfere with a
truck spec’s optimum efficiency

 Reduce road speed to 65 mph, and you lower the engine speed to 1,323 rpm — below the engine’s sweet spot. Performance and gradability are marginal because engine speed is too low. If you run one gear down to improve performance, fuel economy will suffer. In 9th gear at 1,813 rpm, you’re well above optimal fuel economy.

Reducing road speed to 60 mph gives us an engine speed of 1,221 rpm — well below the engine’s sweet spot. Top-gear performance will be extremely poor. You’d really have to run one gear lower, but performance would remain poor as the engine speed is 1,673 rpm, still well above optimal fuel economy, plus you’re final drive ratio is now less the direct.

"Multi-speed transmissions such as 13- and 18-speeds tend not to be impacted as severely as a 9- or a 10-speed," says Mack’s powertrain marketing manager, Dave McKenna. "The top gear step in a 10-speed is 26 to 27 percent. It’s closer to 16 percent with the multispeed transmissions."


Have your say


This is a moderated forum. Comments will no longer be published unless they are accompanied by a first and last name and a verifiable email address. (Today's Trucking will not publish or share the email address.) Profane language and content deemed to be libelous, racist, or threatening in nature will not be published under any circumstances.

*